No products in the cart.
Flamingo Diamond Hard Wax Polish
Not that bad
Save my name, email, and website in this browser for the next time I comment.
There are no reviews yet.
Remove the air filter and spray exterior carburetor linkage. To remove gum and varnish from the throttle plate, spray short bursts into the carburetor bowl while engine is idling.
AUTOMATIC CHOKE: Open and close by hand while spraying on choke valve shaft. If the choke continues to stick, remove the choke cover. Start engine and spray vacuum cylinder while idling.
PCV VALVE: Disconnect the crankcase side of the valve and spray short bursts into the exposed end. THIS MUST BE DONE WHEN THE ENGINE IS COLD. Allow to penetrate. Start the engine and once again spray into the exposed end of the valve. Wait a minute and turn the engine off.
MANIFOLD HEAT CONTROLS: Spray on exposed ends of the heater valve when the engine is cold. Allow to penetrate. Move the counterweight back and forth until the valve frees up